Original URL : https://www.retrobrewcomputers.org/doku.php?id=builderpages:plasmo:z80mb64:newcfmacro
 Snapshot date: 2024-04-14
 Generator    : wayback-archiver

For people with Z80SBC64 and Z80MB64: attached is a TeraTerm Macro and files that allow you to install CP/M software in a new CF disk. This is the macro I ran when I want to create a new CF disk. Unzip and place all files in c:\teraterm\newcf; then run the macro “NewCF.TTL” in TeraTerm. It will perform the following tasks:

Run RAM diagnostic for 5 seconds

Format drives A:, B:, C:, D: <–please note all previous files will be erased

Install CP/M2.2 BDOS/CCP/BIOS

Install CP/M 3 CPMLDR

Install SCMonitor

Install XMODEM in new CF disk

XMODEM UNARJ.COM to decompress subsequent files

XMODEM CP/M 2.2 system files

XMODEM CP/M 3 system files

XMODEM ZORK1,2,3

XMODEM HiTech C 3.09

Decompress CPM 3 system files into drive A:

Decompress CPM 2.2 system files into drive B:

Decompress HiTech C files into drive C:

Decompress ZORK1,2,3 into drive D:

It takes about 7 minutes to do all above, but they are all done automatically. Here is a YouTube video of the entire process. https://youtu.be/0L9N5JCj-V8

While this macro works well, it can use some improvements:
1. A way to slow down the 'send' command so there is small delay between each character sent. Right now I send 5 characters, wait 100mS, send 5 more, wait, etc. It works, but it is ugly.
2. A way to set the default directory for MACRO. Right now I specify the filepath to “c:\teraterm\newcf”; I like to have more flexibility where files are stored.

All files required to create a new CF disk