Original URL : https://www.retrobrewcomputers.org/doku.php?id=boards%3Asbc%3An8%3An8
 Snapshot date: 2026-04-06
 Generator    : wayback-archiver

Gallery

The N8 is intended to be a “home brew” style computer in the style of early 1980's all-in-one home computers with a usable set of features such as color graphics, audio, an assortment of mass storage options, a variety of ports, etc. Although a bus expansion is supported no additional boards are required.

The N8 is designed so builders can assemble it themselves using common tools such as basic soldering iron, VOM, etc. It is a simple two-layer board construction using all commonly available plated-through-hole (DIP and PLCC) components without requiring any SMT skills, programmable logic devices, etc.

A quick summary of the N8 features:

ROM Support included in

UNA BIOS

ROMWBW

C-BIOS MSX Compatible BIOS

Various MSX Game Cartridges supported by C-BIOS

NOTES:

On release 2312 of the PCB the SD circuit was changed, so the MSX CBIOS needs to be recompiled with different settings to work with older boards

There have been reports of fragile/missing traces on the 4314 boards (U11-17 to U8-1) and on the 2312 boards (U58-13 to U24-2) both in the SD card circuit

The version of the MSX CBIOS has been tested on the 4314, 2312 and 2511 versions of the board.

Board versioning scheme is WWYY where WW is the week number and YY is the year number. So, 2312 means week 23 of year 2012.

Changes and Errata

Successful serial communication with the ZS180 requires the DCD to be low. On the N8 board DCD is pin 47 of the ZS180. This line is tied to ground via resistor R42 (2K2). This resistor value may be too high. If you are unable to see serial output then try bridging this resistor so pin 47 is connected to ground.