/* Imported from Wayback Machine Original URL : https://www.retrobrewcomputers.org/doku.php?id=builderpages:plasmo:crc65:modified_rc2014_bus Snapshot date: 2025-09-09 Generator : wayback-archiver */ ==== Table of Contents ==== [[#modified_rc2014_bus_for_crc65|Modified RC2014 Bus for CRC65]] [[#introduction|Introduction]] [[#signal_definiton|Signal Definiton]] ====== Modified RC2014 Bus for CRC65 ====== ===== Introduction ===== CRC65 has an expansion bus that's based on RC2014 bus. It is a single-row, 39-pin, right-angle male connector. The addresses, data and power signals are same as RC2014, many of the control signals are also the same. The different signals are 6502-specific. [[https://www.retrobrewcomputers.org/lib/exe/fetch.php?tok=9b6a68&media=https://www.retrobrewcomputers.org/lib/plugins/ckgedit/fckeditor/userfiles/image/builderpages/plasmo/crc65/crc65_modified_rc2014bus.jpg|{{https://www.retrobrewcomputers.org/lib/exe/fetch.php?w=600&h=351&tok=bc5539&media=https%3A%2F%2Fwww.retrobrewcomputers.org%2Flib%2Fplugins%2Fckgedit%2Ffckeditor%2Fuserfiles%2Fimage%2Fbuilderpages%2Fplasmo%2Fcrc65%2Fcrc65_modified_rc2014bus.jpg?600x351|www.retrobrewcomputers.org_lib_plugins_ckgedit_fckeditor_userfiles_image_builderpages_plasmo_crc65_crc65_modified_rc2014bus.jpg}}]] ===== Signal Definiton ===== ^Pin Number^Signal Name ^ |1 |Address 15, A15 | |2 |Address 15, A14 | |3 |Address 15, A13 | |4 |Address 15, A12 | |5 |Address 15, A11 | |6 |Address 15, A10 | |7 |Address 15, A9 | |8 |Address 15, A8 | |9 |Address 15, A7 | |10 |Address 15, A6 | |11 |Address 15, A5 | |12 |Address 15, A4 | |13 |Address 15, A3 | |14 |Address 15, A2 | |15 |Address 15, A1 | |16 |Address 15, A0 | |17 |Ground | |18 |VCC | |19 |Spare | |20 |Reset | |21 |PHI2 Clock | |22 |Interrupt, IRQ | |23 |Non-maskable interrupt, NMI | |24 |Read/write, RWB | |25 |RDY | |26 |SYNC EXIO (note: require engineering change for Rev0 PCB)| |27 |Data, D0 | |28 |Data, D1 | |29 |Data, D2 | |30 |Data, D3 | |31 |Data, D4 | |32 |Data, D5 | |33 |Data, D6 | |34 |Data, D7 | \\