Differences

This shows you the differences between two versions of the page.

--- builderpages:dylanmc:z80sbc [2021/01/22 10:27] – Revision from 2021-01-22
+++ builderpages:dylanmc:z80sbc [2026/06/15 12:59] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
+/* Imported from Wayback Machine
+   Original URL : https://www.retrobrewcomputers.org/doku.php?id=builderpages:dylanmc:z80sbc
+   Snapshot date: 2020-08-09
+   Generator    : wayback-archiver
+*/
+I'm starting from ground zero, so this board is my first S100 component. That means I don't have a backplane / power supply to plug it in to (that's my next project), and I don't have any kind of system monitor / front panel to interact with it.
+Fortunately, John's instructions don't entirely assume those are available to you. Still, I did have to go pretty far before learning I didn't make any early mistakes.
+I decided to power the board directly with 5V, plugged into headers soldered in where the Pololu regulator will eventually go. With that, I was able to verify the first few liveness checks using assembly code burned to EPROM (also a first for me - the cheap-o knockoff programmer worked great).
+Here's a photo of my first major milestone: the system monitor prompt.
+[[builderpages:dylanmc:z80sbc|{{builderpages:dylanmc:gplus135310056.jpg?200}}]]