Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| boards:sbc:sbc_v2:sbc_v2-004:development [2025/04/23 07:35] – Revision from 2025-04-23 | boards:sbc:sbc_v2:sbc_v2-004:development [2026/06/15 12:34] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | /* Imported from Wayback Machine | ||
| + | | ||
| + | | ||
| + | | ||
| + | */ | ||
| + | |||
| + | ====== SBC V2-004 Development ====== | ||
| + | |||
| + | Updated design to include the following changes. | ||
| + | |||
| + | Correction of reset circuit. | ||
| + | |||
| + | Addition of speaker circuit. | ||
| + | |||
| + | Add solder jumpers for bypassing DS1210. | ||
| + | |||
| + | Move status LED to corner of board as per other ECB boards. | ||
| + | |||
| + | Align serial connector pinout and functionality to SBC Z180 Mark IV | ||
| + | |||
| + | Add max232 solder jumpers for TTL level output. | ||
| + | |||
| + | Add onboard super capacitor. | ||
| + | |||
| + | Incorporate ppide. | ||
| + | |||
| + | Update to Kicad 5. | ||
| + | |||
| + | Add jumper settings to silkscreen. | ||
| + | |||
| + | Move reset switch to edge of board and remove reset jumper. | ||
| + | |||
| + | Add jumpers to configure battery backup source. | ||
| + | |||
| + | Add cpu clock divider to support MSX. | ||
| + | |||
| + | Default to hard Kontron reset mode. | ||
| + | |||
| + | Add User input button on UART Ring Indicator line (for recovery mode in ROMWBW) | ||
| + | |||
| + | Other ideas to be considered: | ||
| + | |||
| + | RAM access over ECB-BUS. | ||
| + | |||
| + | Renumber all parts. | ||
| + | |||
| + | Most recent Kicad files can be found here: https:// | ||
| + | |||
| + | Version V: | ||
| + | |||
| + | {{[[lib: | ||
| + | |||
| + | {{[[lib: | ||
| + | |||
| + | Version: R: | ||
| + | |||
| + | {{[[lib: | ||
| + | |||
| + | {{[[lib: | ||
| + | |||
| + | Sound circuit sourced from TRS-80 circuit: | ||
| + | |||
| + | [[https:// | ||
| + | |||
| + | CPU-Clock switching sourced from ZX-TURBO circuit: | ||
| + | |||
| + | {{[[lib: | ||
