Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| boards:ecb:scg:changes [2024/08/08 22:58] – Initial import from Wayback Machine | boards:ecb:scg:changes [2026/06/15 12:50] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | /* Imported from Wayback Machine | ||
| + | | ||
| + | | ||
| + | | ||
| + | */ | ||
| + | |||
| + | ====== Changes & Errata ====== | ||
| + | |||
| + | ===== Kontron Reset modification ===== | ||
| + | |||
| + | The current SCG design has the reset circuit hardwired for Legacy/ | ||
| + | |||
| + | Disconnect pin 8 of U12 from C31 of the ECB connector. | ||
| + | |||
| + | Connect pin 8 of U12 to C26 of the ECB connector. | ||
| + | |||
| + | The easiest way to do this is the cut the C31 wire on the ECB connector and then link C31 pad to C26 pad. | ||
| + | |||
| + | ===== Version 003 changes ===== | ||
| + | |||
| + | On version SCG-002 and prior, John Coffman identified that the I/O select circuit is qualified only by IORQ# (low). It should be further qualified by M1# (high). The board will erroneously select on an Interrupt Acknowledge (IORQ# low, M1# low). This has been correct in SCG-003. | ||
| + | |||
| + | To update version 002 board: | ||
| + | |||
| + | Cut track between pin 13 and pin 14 on IC U10. | ||
| + | |||
| + | Link pin A20 on ECB connector to pin 13 on IC U10. | ||
| + | |||
| + | If socket on IC U10 prevents cutting the track then lift pin 13 and link the pin to A20. | ||
| + | |||
| + | ===== Version 002 information ===== | ||
| + | |||
| + | [[https:// | ||
| + | |||
| + | [[https:// | ||
| + | |||
| + | Manufacturing Files: [[https:// | ||
| + | |||
| + | [[https:// | ||
| + | |||
| + | For information on prior board versions, see the [[n8vem-pbwiki-archive: | ||
